How tight do you torque wheel bearings?
The nut on the spindle should be tightened until snug, with no side-to-side play in the hub and then backed off, about a quarter of a turn. The nut finger should be tight until the castle nut or cotter pin is used.
What is the torque spec on hub assembly?
The torque specifications for GM wheel hubs generally range between 107 to 225 foot-pounds, depending on the year and model.
Do wheel bearings need to be torqued?
The wheel bearings are responsible for allowing the wheels to be able to turn properly on the spindle. The wheel bearing is held in place by an inner and outer nut. Both of these nuts have to tightened and torqued for the wheel bearing to be able to work properly.
How tight should a bearing nut be?
The nut on the spindle should be tightened until snug, with no side-to-side play in the hub and then backed off slightly, about maybe a 1/8 of a turn.
What happens if you over torque axle nut?
It’s possible to damage the wheel, rotor, and hub assembly. The wheel can come off if over-torquing the nuts/bolts is done. It happens, but it doesn’t happen a lot. The only way to tighten them is with a Torque wrench.
What is the torque for axle nut?
For a double nut or jam nut system, bend the lock tab or install the set screw after the outer nut is torqued to 200 ft-lbs. For one-piece spindle nut systems, torque the nut to a minimum of 300 ft-lbs.
Do you need to torque axle nut?
Proper torque is critical for two reasons. First, it secures the axle nut so it won’t work itself loose and back off. Second, the proper torque keeps the correct load on a hub assembly needed for longer bearing life. Torque specifications can be different, even for the same hub, if it’s multiple applications.
What are the torque specs for wheels?
New wheels should be re-torqued after the first 50 to 100 driving miles.
| Hardware Bolt or Stud Size | Typical Torque Range in Ft/Lbs | Minimum Number of Turns of Hardware Engagement |
|---|---|---|
| 14 x 1.25 mm | 85 – 90 | 9 |
| 7/16 in. | 70 – 80 | 9 |
| 1/2 in. | 75 – 85 | 8 |
| 9/16 in. | 135 – 145 | 8 |
Can you over tighten wheel bearings?
What happens if you over tighten axle nut?
It’s possible to damage the wheel, rotor, and hub assembly. The wheel can come off if over-torquing the nuts/bolts is done.
What is the torque specs for a axle nut?
How big is a 1998 Dakota Durango wheel bearing nut?
I read in the haynes book for 2000-2003 dakota’s its 185ft-lbs but I want to be 100% sure its the same for my 1998 dakota. ‘Till the impact stops!
What should the torque be on a Dodge wheel?
If you are planning on installing a wheel on your Dodge, it is important to be aware of the manufacturer’s recommended torque settings.
What are the torque specs for a Dodge Viper?
Dodge Wheel Lug Nut Torque Specs Recommendations Model Trim Year Range Torque VAN/WAGON – B350/3500 BASE 225 / B350/3500 1989 – 2003 150 ft-lbs VIPER 2 DOOR / CABRIOLET 1992 – 2010 100 ft-lbs VIPER BASE / ALL 2013 – 2018 110 ft-lbs VISTA WAGON / P165/80R13 1985 – 1991 60 ft-lbs