How much fullness do you need for eyelet curtains?
Heading Styles and Curtain Fullness – An eyelet curtain will usually have 2 x fullness = 100% of the track width. – A pinch pleat curtain requires more fabric to sew in the pleats as it gathers up tighter. As such you will require 2.5x the track width or 150% fullness.
Do eyelet curtains need to be double width?
Measuring for ready made eyelet curtains is very simple. There is no need for exact or precise measurements. Double the width to determine the total curtain width you need for your window.
How do you calculate fabric for eyelet curtains?
Eyelet curtains: measure the drop from 1”/2.5 cm above the pole to where you want the curtain to finish. Tab top curtains should be measured from the top of the pole, then subtract the length of the tabs you are making.
How do you use eyelet tape and rings?
Pin the eyelet tape along the top edge of the fabric and sew into place. Draw around the inside of each ring with a fabric pen, then cut out these circles to create the eyelet holes. 3) Press the eyelets into place at the front of the curtain.
Can you convert eyelet curtains to pencil pleat?
I convert a lot of eyelet curtains to pencil pleat while shortening them, it’s almost always cheaper than buying fabric to have them made, especially when the sales are on. These are from Dunelm if you like the look of them.
How do you measure for eyelet curtain width?
Measuring for Eyelet Curtains Simply measure between the finials (the decorative ends) to obtain the width. Drop: The inner edge of the eyelet is set down 3cm from the top of the curtain so you need to allow for this when measuring or your curtains will be 3 cm too short!
Does it matter if curtains are too wide?
A common rule for displaying curtains properly says the curtains finished width should be at least 2 times the width of your window (if not more – sheers can be 3 times the window width) to achieve a look of proper fullness.
How do you calculate curtain width?
Measure the width of the rod from left to right. A common rule for displaying curtains properly says the curtains finished width should be at least 2 times the width of your window (if not more – sheers can be 3 times the window width) to achieve a look of proper fullness.
How much eyelet tape do I need?
You wild need approx. double fullness. Note: Unlike most heading tapes where the tape is cut to fit the final curtain width, the curtain must be adjusted in width to fit the eyelet tape. The tape must be used with an even amount of rings, i.e. 4-6-8-10 etc.