Categories :

How do I get my Brother printer out of error mode?

How do I get my Brother printer out of error mode?

You can do it in a few simple steps by unplugging the power cord from the wall outlet and then again switching it on. You can update or re-install the printer driver. According to many Brother Printer users, the Error State is often caused by the corrupting of the printer drivers. The technicians also suggest the same.

Why does my Brother printer keep saying error?

Difficulty printing from your PC can occur for various reasons. The most common reason a networked Brother machine may stop printing, is because the connection between the computer and the Brother machine is lost. This can occur as a result of wrong settings or configuration of the printer driver.

How do I fix Error 48 on Brother printer?

Troubleshooting Print Head problem

  1. Plug out the printer power cord.
  2. Lift the scanner cover gently.
  3. Look inside the printer. If there is any paper part jammed, remove it.
  4. Do check for any scrap beneath the printer head.
  5. Move the printer head to the center if it is hung in the right or left corner.

How do I get my printer out of error state?

Sometimes, simply restarting both your computer and printer can be the solution to the “printer in error state” issue. Power off your printer and computer completely, leaving them in this state for a few minutes, then turn them on again to see if the problem is gone.

How do I get a Brother printer back online?

And last, go to ‘printer’ in the menu window and tap ‘use printer offline’ and automatically this action will reconnect the printer ‘online’ from the ‘offline’ status. The process is really simple as it will turn a brother printer offline to active status, so printing jobs perhaps in a queue can continue.

How do I clear the error on my Brother HL 2270dw?

Reset drum light on Brother HL-2270dw

  1. Open the front door to the printer.
  2. Press and hold the “Go” button until all four status LEDs turn on (Toner, Drum, Error, Ready).
  3. Release the “Go” button.
  4. Close the front door of the printer.

Why is my Brother printer printing out blank pages?

If there is insufficient ink in your cartridge, your Brother printer may print blank pages. If the ink cartridge is not installed properly or is of low quality, it will print blank pages. Wrong printer driver settings can lead a printer to print blank pages. Dirty printheads of printers can print blank pages.

How do I fix my brother printer Error 46?

Machine Error 46 indicates that the ink absorber pad is full and needs replacing. You will need an engineer to replace this. If your machine is out of warranty, please contact Brother Customer Service from “Contact Us”. The ink absorbers hold liquid and dried ink after it has been purged from the print head.

How do I reset my Brother printer?

Press the Up arrow key select Reset.

  1. Press the Settings button.
  2. Press All Settings.
  3. Press Initial Setup.
  4. Press Reset.
  5. Press All Settings or Factory Reset (depends on which model you have).
  6. Press Yes.
  7. Press Yes again and hold for two seconds.

How do I fix init unable 48?

“Unable to Init. 48”

  1. Confirm the error message appearing on the display.
  2. Press Stop/Exit to temporarily clear the error message.
  3. Unplug the machine from the power outlet.
  4. Print a User Settings Report to test.
  5. Your machine will require service.
  6. Transferring stored faxes to another machine.