Categories :

What is a tenon maker?

What is a tenon maker?

Tenon cutters are the log furniture tools that cut tenons on the end of your log rails and spindles. These handy implements work to trim the end of your log rails, allowing them to be inserted into other logs to create the base structure of your furniture project.

What is a tenoning jig used for?

A tenoning jig locks a board against a plate and holds it tightly in place so it can cut cheeks and shoulders on all four sides of a tenon. A stop piece keeps the board square in both directions. Cutting on all four sides of a tenon allows for a better fit, thus making the joint easier to conceal.

What is a loose tenon joint?

Despite its odd name, “loose-tenon” joinery is one of woodworking’s tightest methods of joining parts. It’s also one of the most versatile. Structurally, a loose-tenon joint resembles a traditional mortise-and-tenon joint, and it’s every bit as strong. Both joints gain their strength from a thick, solid-wood tenon.

How do you make wood round without a lathe?

Without an easy means of creating round parts, lathe-less woodworkers are stuck searching for ways to squeeze square pegs (e.g. leg or spindle stock) into round holes. Fortunately, there’s a simple solution. Using your router table and a few bits, you can mill perfectly round stock for spindles, legs, and more.

How can I Make my tenon jig square?

The second handle also adds more bracing to keep the jig square. Now’s a great time to check the squareness of the jig. You can adjust this by trimming a small amount off of the bottom of the sub-face if it’s leaning back, or off the bottom of the back it it’s leaning forward: At this point, that amount cut off should not be a lot.

Why are there two handles on a tenon jig?

Two handles is an improvement over the first jig. There will be a handle to hold onto if I turn it around to use it on the other side of the blade: The second handle also adds more bracing to keep the jig square. Now’s a great time to check the squareness of the jig.

How is a clamping bar for a tenon made?

The clamping bar is made from five separate pieces and glued together to form the slots: I used if for the first time to make the cheek cuts to form a tenon on the end of this piece of wood: It’s also handy for cutting raised panels.

How does a jig slide over a fence?

Either adding shims or by trimming some off, the jig must slide smoothly without play. The sub-face is then screwed on with the top and back clamped over the fence: