Categories :

How do I check the status of my APC battery?

How do I check the status of my APC battery?

To manually start a Self Test from the UPS:

  1. LCD Screen Models: Go to the “Test & Diags” menu, then select “Self Test”
  2. Legacy Models (No LCD Screen): Press and hold the “I/Test” button. After several seconds the UPS will switch to battery. You can then release the button and the test will continue to completion.

How do I check the health of my UPS battery?

To test any battery, it must be fully charged first. After charging, the surface charge must be removed and this can be done by briefly turning on the headlight, for instance, then let the battery sit for a couple of hours. After this, the battery is ready for both tests.

How do I know if my UPS battery needs to be replaced?

The Low Battery Alarm Has Sounded Most UPS systems come with a low battery alarm. The machine will run a periodic self-test, only giving an alert signal when a battery replacement is required. Usually, this signal takes the form of an indicator light or alarm sound.

What is the expected life of my APC UPS battery?

three to five years
Most APC batteries should last three to five years. There are many factors which affect Battery life including environment and number of discharges.

How do you check if UPS is working?

To perform a UPS diagnostic test

  1. On the Diagnostics menu, click Test Hardware.
  2. Click the System Test or Battery Test tab.
  3. Click Test….
  4. At any time during the test or after the test is performed, click the Results button to update the result field.
  5. The status of the procedure is shown in the status column.

How do I reset my APC battery?


  1. Turn off UPS via control panel on front of unit.
  2. Unplug UPS from the wall.
  3. Disconnect the battery. This is a plug on the rear of the unit labeled “ BATTERY CONNECTOR” (You may hear an audible click from the UPS)
  4. Reconnect the battery.
  5. Turn on UPS.
  6. Plug UPS into the wall.
  7. Test for original failing condition.

What is the life of UPS battery?

What is the average lifespan of UPS batteries? The standard lifespan for VRLA batteries is three to five years; for wet-cell batteries it’s up to 20 years. However, expected life can vary greatly due to environmental conditions, number and depth of discharge cycles, and adequate maintenance.

How do you check if a battery is bad?

The most common symptoms that come with a bad battery include:

  1. Battery light illuminated on the dashboard.
  2. Engine cranks slowly when starting.
  3. Vehicle requires frequent jump starts.
  4. Clicking when you turn the engine.
  5. Lights are dim.
  6. Car won’t start.

Should I keep my UPS plugged in all the time?

Yes. It is necessary to constantly charge the UPS because most power interruptions that place a demand on the battery are so quick you might not even notice them. If your house power browns down (goes below 110VAC, but does not fail, your ups will discharge the battery to compensate.

How long will a 1500VA UPS last?

For a common measurement, a 1500VA-rated UPS will run a computer for less than an hour. If you get more than 10 minutes of run time, you can run a PC, networking gear, and monitor.

How can I recalibrate my UPS?

Business Edition – Click on the name of your UPS, then select Diagnostics. Under “Initiate Diagnostics” select “Calibration” from the dropdown and click apply. Network Management Card – From the “Tests” menu select “UPS”. Select “Runtime Calibration” and click “Apply”.

How do I reset my APC alarm?

1) Turn off and unplug the Smart-UPS from wall. Remove any attached load. 2) Press and hold the power button (labeled “”I/TEST”” on legacy non-LCD screen units) on the front of the UPS until you hear a LONG beep. 3) Let go DURING the long beep.

Where can I Find my APC ups serial number?

The serial number is not on the front of the unit, but can be found on a sticker on either the bottom or rear of your product. The location of the label as well as letter and number sequences will vary by model and product type.

Are there any warranties on APC UPS products?

APC products are backed by comprehensive warranties and policies to afford basic peace of mind right out of the box.

Which is the UPS management software for APC?

Monitor and manage your APC Uninterruptible Power Supply (UPS) with our free UPS management software, PowerChute. What is APC PowerChute? APC PowerChute™ is UPS management software enabling graceful system shutdowns and providing energy management capabilities.

How do I install APC on my computer?

Connect the APC USB cable to your PC’s USB port. Then download the software directly onto your computer, this will only take a few minutes. From there, the software will recognize the battery backup and connected devices. Follow the user guide for installation instructions.